Mechanical FilmingStart a project

Mechanical Filming / blog

The benefits of 3D animation in manufacturing.

3D animation earns its place in a manufacturing business when the thing you need to show cannot be filmed — because it is hidden inside an assembly, because it moves too fast or too slowly to read, or because it has not been built yet.

The five it is actually good for

What it costs in real hours

Most pages in this category quote a cost per minute, which tells a manufacturer nothing. Here are real figures from our own test assembly rather than an industry average.

A 29-second single-mechanism film runs to 692 frames at 24 frames per second. On a 212-part test assembly, those frames rendered in about 82 minutes at 1280×720 with 96 samples per frame.

The useful part of that number is how small it is. Rendering is the cheap, predictable end of the job. The days go into modelling the parts to the drawings, resolving the places where the drawings disagree with each other or with the prototype, and the revision rounds after the first cut. When a quote for mechanism animation looks high relative to its runtime, that is what is being paid for — and when a quote looks suspiciously low, that is usually the part being skipped.

Our own published bands for a single-mechanism short film run $450 to $1,500, priced by how complex the mechanism is rather than by how many seconds come out of it.

Which type suits which stage

StageWhat to makeWhy
Design reviewPlain motion study, no materialsNobody should be judging chrome while the geometry is still moving
Investor or buyer pitchShort film, 20–40 seconds, finished materialsLong enough to show the cycle, short enough to hold a room
Assembly instructionsExploded view, stills or a slow sequenceThe order of assembly is the content; motion is secondary
Installer and service trainingInteractive or step-by-stepThe trainee needs to control the pace, not watch a film
Trade show screenSilent loop, no narrationThere is no audio on a show floor and nobody watches from the start
Catalogue and spec sheetStills rendered from the same modelAlready paid for once the model exists

When it is the wrong tool

This is worth saying plainly, because the answer is often “don't”.

Common questions

What is 3D animation used for in manufacturing?

Showing how a product works before it exists, showing motion that cannot be filmed because it happens inside a sealed assembly, and producing one model that then serves sales, assembly instructions, training and trade show loops.

Is animation cheaper than filming the real machine?

Not always. Filming is usually cheaper when the machine exists, runs, and can be seen working from outside. Animation wins when the product is not built yet, when the motion is hidden inside the assembly, or when the same model has to serve several outputs.

Do you need CAD files?

CAD is fastest. PDF part drawings and a parts list work well. Where neither exists the parts can be modelled from measured photographs, which takes longer and should be quoted that way.

How long does a short mechanism animation take?

The render is the short part. On a 212-part test assembly a 29-second film came to 692 frames and rendered in about 82 minutes. The modelling, the drawing checks and the revisions are where the days go.

Can the same model be made interactive?

Yes. The geometry can be rebuilt to run in a browser so a trainee takes the mechanism apart themselves, embedded in a course page or a service portal.

Where projects start

Projects start at $499.

  • 10–15 seconds, one mechanism moving
  • Built from your CAD or part drawings
  • One revision round
  • Delivered in two weeks

Start a project

The $499 starter is a short single-mechanism clip, open to new clients, one project each. Technical and device work is quoted by scope and typically runs $2,500–$12,000. Longer films, full teardowns and interactive versions are quoted from the same model.

Commissions open · request a quote

Tell us what moves.

Request a quote

Related